need someone to reload these rounds or that has some will pay whatever
-
ODT Gun Show & Swap Meet - May 4, 2024! - Click here for info
243 wssm ??
- Thread starter Madison Daniel
- Start date
You could always get a cheap hand reloading set up for it & roll your own. It's pretty easy, just need a few extras like a reloading manual, caliper, dies & cheap hand case trimmer.
https://www.midwayusa.com/product/650614/lee-breech-lock-hand-press-kit
For the 243 wssm it'd be a good idea to buy a lot of brass for it. Some cartridges don't last long & manufactures tend to stop making components for it after awhile or just do it seasonally since demand is low.
https://www.midwayusa.com/product/650614/lee-breech-lock-hand-press-kit
For the 243 wssm it'd be a good idea to buy a lot of brass for it. Some cartridges don't last long & manufactures tend to stop making components for it after awhile or just do it seasonally since demand is low.
Remember not all chambers are the same some short, some long, and sometimes the book is an average and may not work on every gun.
brass and bullets are hard to find. about 60.00 for a box of 20
Ammo:
https://www.outdoorlimited.com/243-WSSM-RIFLE-Ammunition-for-Sale-s/2408.htm
https://www.dowdlesports.com/Winchester-Ammo-SupX-243-WSSM-100gr-Power-Pt_p_39671.html
I understand your problem, I have a favorite rifle that is chambered in 375Winchester. I bought the dies, shell holder, all the brass I could get, and all of the boxed ammo I could find.
Depending on who made your gun, and who you talk to, you might be able to convince the manufacture to rechamber or rebarrel that rifle in a caliber that you can use. It might be a better deal than scrounging for ammo.
If you buy the dies and shell holder, someone located near you will probably help you. I am betting that no one on this forum has the setup that you need or they would have offered. The dies are available, and you can make your brass from resizing either 223wssm or 257wssm.
https://www.outdoorlimited.com/243-WSSM-RIFLE-Ammunition-for-Sale-s/2408.htm
https://www.dowdlesports.com/Winchester-Ammo-SupX-243-WSSM-100gr-Power-Pt_p_39671.html
I understand your problem, I have a favorite rifle that is chambered in 375Winchester. I bought the dies, shell holder, all the brass I could get, and all of the boxed ammo I could find.
Depending on who made your gun, and who you talk to, you might be able to convince the manufacture to rechamber or rebarrel that rifle in a caliber that you can use. It might be a better deal than scrounging for ammo.
If you buy the dies and shell holder, someone located near you will probably help you. I am betting that no one on this forum has the setup that you need or they would have offered. The dies are available, and you can make your brass from resizing either 223wssm or 257wssm.
Check with Grafs& sons reloading they have some hard to find ammo!
