Anybody local who can throat a barrel?

[Glockadopoulos]

I just need an aftermarket SS Glock barrel throated so I can load my 9mm ammo a little longer. Any good smiths locally who can handle the jobs?

 

[Megawolf]

I dont know what that is but it sounds right. Im in!

 

[Kahrnut]

Check with Mr. Dremel.

 

[3clicks_Off]

Dorns in Macon has done barrel work for me and did a good job or send it to Que's bolt and barrel works in Alabama if he isn't covered up.

 

[fast306stang]

Dorns in Macon has done barrel work for me and did a good job or send it to Que's bolt and barrel works in Alabama if he isn't covered up.

If I'm not mistaken, Dorn's has been out of business for about 20 years now...

 

[jpm2953]

to run 9mm major?

 

[bambam]

Check with Mr. Dremel.

LOL

 

[3clicks_Off]

If I'm not mistaken, Dorn's has been out of business for about 20 years now...

Probably been that long since I had them work on anything. I used to have family up the road in Forsyth and had him to pull ream a worn out 22 bolt gun to make it a smooth bore and install a KDF break on a 300 weatherby mag I was too brittle to shoot.
He did good on both.

 

[palmettomoon]

If I'm not mistaken, Dorn's has been out of business for about 20 years now...

Mike (the son) is a member of the club, super nice fellow. I do not think he takes work however or I'm sure he'd have mentioned it.

 

[Glockadopoulos]

to run 9mm major?

Possibly, though mainly to be able to load 124 PD JHP’s not cartoonishly short. There were a few names mentioned on Enos forums, but none of them will take on work.