The factory 4 pistons are nice. That's what's on my tundra. Look for 03-06 knuckles and just upgrade. Pads go in from the top of the caliper so no more drama
-
ODT Gun Show & Swap Meet - May 4, 2024! - Click here for info
Broke off a bolt today. (Fixed)
- Thread starter MRM
- Start date
That is what I am putting on. They are bolt-on ....provided you don't bust the bolt!
Tanerite.... about a five gallon bucket full
Phoenix Parts in Doraville has the left and right side knuckle for $85 each depending on which one you need. That's the closest one I could find to Dawsonville
I picked up one at Tallant Bros for 75 in great shape with the ball joints, hub, brake lines, bolts, and even 4 lugnuts.
Thanks!
Hopefully the swap will be uneventful.
Thanks!
Hopefully the swap will be uneventful.
I found a torch head also. I going to heat it up good too.
The only thing I have to try and save is the tie rod end thank goodness.
Spray it all down with PB BLASTER, over nite and then it should come off in the morning...
I sprayed it all with pb plaster.
I broke most of it loose today.
I pulled out my Tourqe Wrench also.
My laziness cost me this time.
Everything will be torqued to spec going back together!
I have to pick up a 24mm socket and a tie rod tool.
I broke most of it loose today.
I pulled out my Tourqe Wrench also.
My laziness cost me this time.
Everything will be torqued to spec going back together!
I have to pick up a 24mm socket and a tie rod tool.
