• ODT Gun Show & Swap Meet - May 4, 2024! - Click here for info

CERAKOTE QUESTION!!!

I would lightly sand blast with 120grit aluminum oxide, then use H-series cerakote at cured at 175° for two hours.

Something else you're missing is it's extremely important to bake your parts before spraying an oven cured product. Because there is oils and contaminates that will surface once it's heated. That's why it's highly recommended to degrease, sandblast, bake, let cool, spray cerakote then bake again.

Very similar to automotive. Some plastic parts go through the same steps prior to painting. Failure to do so results in poor adhesion.
 
Back
Top Bottom