crowning tool needed ***UPDATE***

[loadnplenty]

looks good! can you please follow up with an accuracy report

X2

 

[BHJ]

Being an old Bubbaed up Enfield I'm not expecting much more than minute of deer to 100 which is what it would do before. I certainly hope it'll go from 5-6" and a little iffy at 100 yds down to about 3"-4" and consistent but we will see. It'll have to be an improvement over the crown or lack of that was on it. Probably gonna be at least a couple of weeks before I get a chance to check. Too many irons in the fire right now to get out and shoot and I'm also gonna have to load up some emptys. I'm gonna have several projects to test and refine when I do finally get some time out in the country though.

Again thanks again for the tip $nipertime it sure looks like I got it done properly and I now have a new use for my $6 Lee case cutter.