Looking to have a shotgun stock cut down shorten the LOP for my son. Not sure if that falls into the gunsmith category if I'm better off finding somebody that works with wood more frequently. And leads or advice? Also, looking for a good 24" barrel auto loader 20 ga. Thanks in advance!
-
If you are having trouble changng your password please click here for help.
cutting down Shotgun stock (shorten LOP) need recommendations
- Thread starter ol' 30-30
- Start date
If you have a good table saw, you can cut it off shorter. I did a couple by building a sliding jig to hold the stock securely in place at the correct angle, tape the stock where you are going to cut, mark the cut line on the tape, and run through your saw with a good sharp blade. Then you have to reinstall the pad and grind it to fit. If you take your time it is not really that difficult.
You can also buy a Magpul or Hogue stock with reduced length of pull. The Magpull has spacers to "grow" with him. It's about $105. The Hogue can be found on Amazon for about $60.
Assuming, of course, one of these will fit whichever model shotgun you've got.
Assuming, of course, one of these will fit whichever model shotgun you've got.
