DD vs Noveske 10.5 inch barrel

[Nsegg]

looking at the .300 blk barrel from Daniel Defense and Noveske. Will provide the link to both, who has had experience with either? Is the noveske that much better? Benefits and cons of both please. This gun will be shot primarily suppressed.

https://www.noveske.com/products/300-aac-blackout-barrel

https://danieldefense.com/cold-hammer-forged-barrels/10-3-300blk-pistol-1-8-s2wr-profile-1271.html

 

[Plinker66]

I would buy an 8.5" blackout barrel on sale fer $100 and spend the rest on tacos.

Btw yer two high dollar barrels have different twist rates. They say one is betta fer suppressed.

 

[Duce4trey]

A bunch of people on 300blk talk swear by the KAK Mr. Blond barrels. Here is the one I have and don't have any issues. Save the money and buy ammo or something.

https://www.kakindustry.com/ar-15-p...0-blackout-9-inch-pistol-stainless-barrel-5r7

 

[Plinker66]

Here's a ba fer $120.

https://www.righttobear.com/Ballistic-Advantage-8-5-Barrel-300-Blackout-p/babl300003m.htm

 

[Nsegg]

I am limited to a 10.3 inch because of the rail I'm using. It's a 10 inch RIS II. Do those barrels you alll listed come in a 10-10.3?

 

[Nsegg]

I could always change that up I suppose.. what are some nice lookin rails that will for a 8.5 inch barrel?

 

[Duce4trey]

I run the 9.5 inch rail on my 10.5 inch SBR. They have a 7 inch rail.

https://geissele.com/super-modular-rail-mk4-m-lok-609.html

 

[Plinker66]

I recently put an 8.5" blackout barrel inside a 12.5" tube with a 2" sleeved brake and I absolutely luv it. It throws the blast down range better than all the other unsuppressed ar pistols I've shot.

I've seen pics of similar setups where the tubes have blown out from the side pressure but I believe my setup will hold because of the sleeve on the brake and the holes in the tube. If it blows apart I'll post a pic.

Kinetech makes a nice cheep sleeved brake.

These days the Nordic components NC-1 tubes are gnarly cheap on gnarly gorilla. Three lengths. You can clock them in without a wrench.

$120 barrel + $70 sleeved brake + $70 tube + one $20 rail section.

And you can screw a $3 10-32 swivel stud into the bottom of the tube also.