Engraving?

[jwill130]

Trying to get my ducks in a row before I do a form 1 sbr. Who is everyone using for engraving? I know Dobbs use to do it while you waited, but I understand he’s unavailable right now. Anyone have any recommendations?

 

[rockyfatcat]

$35 laser etched can't beat it
Gearcraft LLC
450 Grove Street North
Dahlonega, Georgia 30533

 

[jwill130]

$35 laser etched can't beat it
Gearcraft LLC
450 Grove Street North
Dahlonega, Georgia 30533

Thank you, had no idea they did it. I’ll call them Monday!

 

[Blk03shkr]

Paul Hendrixson did 4 lowers for me, located in Cumming

 

[Dirty J]

$35 laser etched can't beat it
Gearcraft LLC
450 Grove Street North
Dahlonega, Georgia 30533

That's awesome if Billie does it...

but be advised a typical laser isn't sufficient for ATF requirements. Doesn't go deep enough.

Make sure he knows what you're after...

 

[rockyfatcat]

That's awesome if Billie does it...

but be advised a typical laser isn't sufficient for ATF requirements. Doesn't go deep enough.

Make sure he knows what you're after...

He interrupted another engraving job that absolutely had some real depth to it to do my job. (They were using the laser to remove material from a slide leaving a recessed/protruding surface) He knew exactly what he was engraving and why it was being engraved.

I believe that there are some out there insufficient for ATF requirements. I would find it impossible to believe that the equipment that engraved my lower could be considered to be in that category.
Laser Etching 0.0001 in. Depth
Laser Engraving 0.0001 - 0.005 in. Depth
Deep Laser Engraving > 0.005 in. Depth