If it's not a bullet seated too far out then your dies are likely the culprit. You can try the small base dies or remove 1/32-1/16th on inch off the base of the die allowing the case to be pressed further into it.
I did this on an RCBS .308 die that re-sized fine for my Remington bolt gun but had issues with the bolt closing on a Ruger 77-V and all else was within spec.
I did this on an RCBS .308 die that re-sized fine for my Remington bolt gun but had issues with the bolt closing on a Ruger 77-V and all else was within spec.