Help extracting 440 trigger set screw

[bambam]

O.K. Next time start the drill out side of contact, then finger off power, and before it winds down to a stop, make contact. This could brake more drill bits. The bit is grabbing the hexes of the allen. Try backwards to try to turn it out. If nothing else this sometimes takes the edges of to go forwards with the drill.

 

[BLIP]

Maybe the manufacturer would hook you up somehow.
Might not hurt to ask.

Galloway Precision wasn't much help thus far... offered to send me 2 .23 cent screws a drop of lock tight and a .5 Allen wrench for 10 bucks plus shipping...

 

[MRM]

Galloway Precision wasn't much help thus far... offered to send me 2 .23 cent screws a drop of lock tight and a .5 Allen wrench for 10 bucks plus shipping...

Boo!
I had hope.

 

[BLIP]

Boo!
I had hope.

As did I. I heard the cared about their customers...

 

[BLIP]

None of the above were effective. I'm going to have to seek professional help unfortunately. Too much time and too much money spent in tools, bits And screws that were not effective. Thanks everyone

 

[abeaty2]

Sometimes you can use a small Torx bit If the Allen is rounded. May be worth a shot before you pay someone.

 

[BLIP]

Sometimes you can use a small Torx bit If the Allen is rounded. May be worth a shot before you pay someone.

Thank you. That method was attempted. used to cheap torx to no avail...

 

[BLIP]

I may try Gunlinger if GA GUN CLUB can't help