Looking for custom milling of an ar-15 upper receiver

[RobertC]

I'm looking to use a Fortis Clutch charging handle left handed version but will need a notch milled out of my upper receiver on the right side for the charging handle latch. I rather not butcher it with my rotary tool. Any recommendations?

 

[Double R]

PM sent.

 

[cmshoot]

We can handle that for you at TruPrep in Marietta. I would need the upper and the charging handle.

 

[RobertC]

We can handle that for you at TruPrep in Marietta. I would need the upper and the charging handle.

Hi cmshoot. Double R was able to help me with this. Thanks for the reply! I do go to TruPrep often, good to know the service is available.

Sent from my Pixel 6 using Tapatalk

 

[cmshoot]

Hi cmshoot. Double R was able to help me with this. Thanks for the reply! I do go to TruPrep often, good to know the service is available.

Sent from my Pixel 6 using Tapatalk

Good to go!