• ODT Gun Show & Swap Meet - May 4, 2024! - Click here for info

Machine shop prices

TLB2

Default rank 5000+ posts Supporter
The Hen that laid the Golden Legos
115   0
Joined
May 19, 2010
Messages
5,931
Reaction score
555
Location
Cairo GA
What does it generally cost to have a v8 block bored, honed, cleaned, decked and cam bearings installed?

What does headwork cost? Checking, cleaning and valve job, and milling if needed
 
Last time I had head work done, it was by Dover Cyl Heads in Atlanta. All the local shops I knew about are gone now.

Dover would repair or exchange, still were doing it last time I checked. I think they do block work as well. They have a web site and post prices, IIRC.
 
Work done by Scotts auto machine in fayetteville in 2004. Prices subject to change..
IMG_1806.JPG
 
Local guy is wanting $850
Clean block and install Cam bearings and freeze plugs
Bore to .030 and hone block
Check and possibly deck block
Check heads and grind valves

No crank work
 
I built a 4 bolt main 350 for my Son's Chevelle 15 yrs ago. The short block is still sitting on the eng. stand and heads are still wrapped up. Had the block done and then built the bottom end, had the heads all done and still in wrapper..Can't remember what I paid. Chevelle is now gone, soon I need to get rid of this small block. Health will not allow me to do anything other than say good by to it..Will list it one day..
 
Back
Top Bottom