ODT NFA tracker thread

[BIBM502]

Eform 4
Submitted 10/18/22
APPROVED 2/6/23

The reason this one came back so fast is because the store I purchased the can from changed ownership so they had all their submitted forms expedited so they could change ffl numbers or something. What's even more ridiculous is that the store called me today to say that they submitted it with an error and that it had to REsubmitted so in all reality...

Eform 4 submitted 2/6/23 @ 2:33pm
APPROVED 2/6/23 @ 9:26pm.

 

[AK74U]

You had me excited for a minute!

Eform 4
Submitted 10/18/22
APPROVED 2/6/23

The reason this one came back so fast is because the store I purchased the can from changed ownership so they had all their submitted forms expedited so they could change ffl numbers or something. What's even more ridiculous is that the store called me today to say that they submitted it with an error and that it had to REsubmitted so in all reality...

Eform 4 submitted 2/6/23 @ 2:33pm
APPROVED 2/6/23 @ 9:26pm.

 

[Joe Mama]

1st post.
Eform1 (individual) filed on a Colt lower 12/26 and just got an email saying Status changed to Approved.

 

[BIBM502]

Eform 1
Submitted 1/11/23
Approved 2/15/23

 

[BigMike]

Eform 1, submitted 1-6 approved 2-15. Individual with EFTs.

 

[BIBM502]

Eform 1, submitted 1-6 approved 2-15. Individual with EFTs.

Where did you have the eft done? I'm tired of getting / mailing in paper cards...

 

[Csmithcuz08]

Once it’s approved, what do you do from there? Are there any extra steps?

 

[BIBM502]

Once it’s approved, what do you do from there? Are there any extra steps?

Engraving

 

[Csmithcuz08]

That’s what I was guessing. Where is the best place to go? I can probably do it myself as I’m pretty handy with a dremel. Probably just throw some alumiblack over it when I’m finished

 

[BIBM502]

That’s what I was guessing. Where is the best place to go? I can probably do it myself as I’m pretty handy with a dremel. Probably just throw some alumiblack over it when I’m finished

I just had it done at Southeast laser engraving for $45. Took about 5 minutes. He did it while I waited.