Looking for suggestions here-
I have an Omni Maxx polymer AR pistol, and I'm trying to remove the barrel.
It's on tight (new from the factory) and I would normally heat the barrel and barrel nut to break the loctite (I assume they used it), but I'm concerned that it would damage the polymer upper.
(The same goes for any solvents that I might use).
Anyone have experience with this?
Sent from my SM-G960U using Tapatalk
I have an Omni Maxx polymer AR pistol, and I'm trying to remove the barrel.
It's on tight (new from the factory) and I would normally heat the barrel and barrel nut to break the loctite (I assume they used it), but I'm concerned that it would damage the polymer upper.
(The same goes for any solvents that I might use).
Anyone have experience with this?
Sent from my SM-G960U using Tapatalk