WASR 10/63 (from military parts kit)- Some wear on receiver/barrel, etc.
Newer wood furniture. Front sight is canted, but lines up with rear sight.
Tapco Trigger
Comes with 1 PMAG that I tried to do the bake-lite treatment a while back.
My loss is your gain.
$1000
TV is $1200
I will show you mine if you show me yours- GWL, only if I don't know you, never dealt with you, or if you have feedback of less than 30. Yeah...I'm that guy.
Contact me via Private Message, Direct Message, Smoke Signal, Carrier Pigeon, etc. DON"T ask me to call YOU.
***Need to note, unfortunately, as it happened to me...once, and will only happen once. If I sell/trade a gun with you, and you take apart beyond the normal factory recommended procedures to clean/lube and it breaks...it is your problem. I don't know your gunsmith credentials, if any. I had to eat a gun I sold and this happened. I fully refunded without knowing the full extent of the damage. A couple of gunsmiths later, I was told, when in doubt on removing something involving threads, keep applying oil to loosen it up on a gun- DON'T manhandle it. Lesson learned for me, and now I am putting this disclaimer in.
***Guys, if you have to get permission from your husbands to buy/trade with me, please block me now, as I don't want to deal with you.
Newer wood furniture. Front sight is canted, but lines up with rear sight.
Tapco Trigger
Comes with 1 PMAG that I tried to do the bake-lite treatment a while back.
My loss is your gain.
$1000
TV is $1200
I will show you mine if you show me yours- GWL, only if I don't know you, never dealt with you, or if you have feedback of less than 30. Yeah...I'm that guy.
Contact me via Private Message, Direct Message, Smoke Signal, Carrier Pigeon, etc. DON"T ask me to call YOU.
***Need to note, unfortunately, as it happened to me...once, and will only happen once. If I sell/trade a gun with you, and you take apart beyond the normal factory recommended procedures to clean/lube and it breaks...it is your problem. I don't know your gunsmith credentials, if any. I had to eat a gun I sold and this happened. I fully refunded without knowing the full extent of the damage. A couple of gunsmiths later, I was told, when in doubt on removing something involving threads, keep applying oil to loosen it up on a gun- DON'T manhandle it. Lesson learned for me, and now I am putting this disclaimer in.
***Guys, if you have to get permission from your husbands to buy/trade with me, please block me now, as I don't want to deal with you.
