I try to keep my hands busy and the extra allowance pays for shooting hobbies (and out of trouble with my wife). Located in Richmond Hill, GA (south Savannah). Background: I cut these from real pistons and currently have a stash of new Wiseco's that I'm using. Been fortunate to have my work recognized that others have sent me theirs (from a blown engine or maybe it was sentimental) to do the work on. As long as there's enough area to make something, I'll cut it. Done everything from outboard engine pistons, lawnmower, 4 cylinder auto to Cummins diesel. -If you're on FB, check out my page and search ---> PISTON SKULLS - HANDCRAFTED <---
Goal - keep my hands busy, while not over charging. Compare real pistons on ebay and other sites for similar work. Ebay has a lot of 3D printed stuff.
Below is what I currently have available and turnaround is usually less than three days if I don't have it. Now for the fun part: PRICING - I'm only getting $65 for a single faced piston. There are a few double faced (faces on both sides) that I ask $85 for. Shipping is normally around $11 inside of Georgia.
These are regular auto pistons so the diameter is 4" and they range in height from 2.5 to 3.25 for the biggest. I may even have the wrist pin for them too. Let me know if you want more photos.
Jay (West Key on FB)
Here's the link to my page. I'm not looking for a bunch of followers or BS like that. I want to sell you a piston and make it into something you'll be proud to show off.
www.facebook.com
Goal - keep my hands busy, while not over charging. Compare real pistons on ebay and other sites for similar work. Ebay has a lot of 3D printed stuff.
Below is what I currently have available and turnaround is usually less than three days if I don't have it. Now for the fun part: PRICING - I'm only getting $65 for a single faced piston. There are a few double faced (faces on both sides) that I ask $85 for. Shipping is normally around $11 inside of Georgia.
These are regular auto pistons so the diameter is 4" and they range in height from 2.5 to 3.25 for the biggest. I may even have the wrist pin for them too. Let me know if you want more photos.
Jay (West Key on FB)
Here's the link to my page. I'm not looking for a bunch of followers or BS like that. I want to sell you a piston and make it into something you'll be proud to show off.
Piston Skulls - Handcrafted | Richmond Hill GA
Piston Skulls - Handcrafted, Richmond Hill. 76 likes · 110 talking about this. Keeping my mind and hands busy is also good for my spirit. Prices start at $65 for most all you see on this page.
www.facebook.com
