-
ODT Gun Show this Saturday! - Click here for info and tickets!
Its ALIVEEEEE
- Thread starter b.a.customkydex
- Start date
Great job, but it does look like it needs to slow down a tad!! DD
This is what I start out with
Put it in the big tube
On the rollers.....
In 2.5 hours when I have to leave to go to Cumming I'm going to turn it off then I'll pull it out and take a somewhat after pic.
This is just to clean it to where I can sort by headstamp, and then on to punching primers out and sizing 1700 pieces of LC for Clarke123. Once it's been sized and deprimed it will be ran thru the swager to remove crimp. Once crimp is removed I'll trim to length, chamfer, deburr and then ream the flash hole from the inside. Once ask that's done it'll go back into the tumbler one last time to clean the primer pockets and any left over lube off. At that point I'll package it up and give the ready to load brass to its new owner Mr Clarke123.
Put it in the big tube
On the rollers.....
In 2.5 hours when I have to leave to go to Cumming I'm going to turn it off then I'll pull it out and take a somewhat after pic.
This is just to clean it to where I can sort by headstamp, and then on to punching primers out and sizing 1700 pieces of LC for Clarke123. Once it's been sized and deprimed it will be ran thru the swager to remove crimp. Once crimp is removed I'll trim to length, chamfer, deburr and then ream the flash hole from the inside. Once ask that's done it'll go back into the tumbler one last time to clean the primer pockets and any left over lube off. At that point I'll package it up and give the ready to load brass to its new owner Mr Clarke123.
Last edited:
