• ODT Gun Show this Saturday! - Click here for info and tickets!

Search results for query: *

  1.

    Painting jeep and upgrades suggestions!

    I guess we will find out . A Freind that runs a body shape said he will take them off prep and paint it all the way around for 300 in his spare time. Hopefully it's not rusted out
  2.

    Painting jeep and upgrades suggestions!

    Thanks for the info! I hope not. My freind I am getting it from took it off the front and side and re painted it. He is driving it for the next week to make sure it's good to go then giving it to me for a month and if I don't want it taking it back. I for sure want it . I am already planning...
  3.

    Painting jeep and upgrades suggestions!

    Looking to have some of the diamond plate and roll bars taken off and painted. The underneath is all new and upgraded geared and on 33s . Thinking about a hard top . Any other suggestions Any good paint shops ran by ODT members in Nw GA ? I just picked this up 99 manual trans . I am super...

  4. Any certified mechanic trade labor for guns . See ad

    Hk glock remington colt savage just to name a few

  5. Any certified mechanic trade labor for guns . See ad

    AR15s SkS's nice 12 gauges 9mm handguns ext .

  6. Any certified mechanic trade labor for guns . See ad

    Its leaking fluid into the bell housing. I would go ahead and have them replace the torque converter too.

  7. Any certified mechanic trade labor for guns . See ad

    Needing a trans pulled out of a 2 wheel drive truck and the front seal torque converter bushing and pump replaced . Local shop said 700 not that I mind paying that just have many more spare guns than spare cash . It's a f150 really only looking for certified mechanics not that I doubt any of you...
  8.

    Gmc/chevy tech. Help

    My friend said he thinks they added that connector . I just don't see how or why they needed it to hot wire it . And what went to that ground the klimer Manuel is no help either guess I will be at pull a part looking to take one a part
  9.

    Gmc/chevy tech. Help

    The grounding location that has half a ground matches it to well and it comes down with the rest of the harness so well. It has the factory igntion because the key unlocks the door too but then again any key will start it .
  10.

    Gmc/chevy tech. Help

    It was hot wired and had the igntion punched
  11.

    Gmc/chevy tech. Help

    The back up lights don't work.. but maybe that's the neutral safty switch ? Witch works and gets voltage to my starter
  12.

    Gmc/chevy tech. Help

    Ground by fuse panel that's been cut. The back up lights dont work . The only code it's showing now is shoft soliode b stuck off or proformance. I changed both shift solenoids. Maybe a grounded wire or something stuck in valve body .I hope not .If the neutral safty switch isn't right can it...
  13.

    Gmc/chevy tech. Help

    It seems to all work . The two wires in the wire but are from that connector . The only thing is it will start with any key and run with no key in it . The pass lock system should not allow that. I am going to replace the igntion lock cylinder and need this to be right. I see it coming down...
  14.

    Gmc/chevy tech. Help

    Any gmc guys out there I need alittle help. I have a 2000 s10 and I have a 5 pin connector coming from my ignition I can't find it on any diagram I need to know where it should plug in. Mine has been cut it's purple blue black orange and pink.
Back
Top Bottom