Both of these are 20 ga.
I used a factory laminate English stock that I had laying around for the top one. Cut the stock down and screwed a limbsaver on it. I bought the shotgun for $25. It had a long barrel and severe rusting inside the first several inches of the muzzle. There was no...
I'm not a gunsmith, and I don't know what they use to cut a barrel. I work at a sheetmetal shop and use a cold cut saw. It leaves very little burr. Then I run a tapered sand paper or scotch brite wheel to clean it up. I've never done it to any gun worth much of anything. I buy beat up...
Barrel length is measured from the bolt face to the muzzle. Most folks do this by dropping a dowel down the barrel until it hits the bolt face. Mark the dowel at the muzzle and measure. That is the legal length of your barrel. The minimum length of a shotgun barrel without NFA paper work is...
I have noticed a couple of companies online offering safety levers that function as a bolt hold open and allow manipulation of the safety without removing the firing hand from the grip. However, they run about $60, and I don't have a money tree. But I do have a Dremel tool and access to a spot...