Bead blasting repair?

[wade4auburn]

So, MilSpec308 and I were putting together a 300blk pistol together and while we were hammering the roll pin into the gas block, we jacked up the finish a bit. I was wondering if there was anyone in the metro ATL area that will re-finish/re-bead blast the gas block. Any suggestions would be helpful.

 

[mtdawg169]

If it's a steel gas block, some Birchwood Casey perma blue should do the trick.

 

[wade4auburn]

Thanks, but the gas block is stainless... bluing it would make it worse. Do you know if cerakoting it would cover it?

 

[Trader Jordon]

Cerakote would cover it yes.... But must be blasted first. I can get you some help in N. Ga but not sure of Atlanta Area.

 

[wade4auburn]

Yeah, I figured. How much to re-blast? Where in N. GA?