Colt Delta Elite 1911 10mm- Custom Cerakote. DS serial prefix says it was once a stainless finish.
Comes with 1 factory blued 10mm Colt magazine. Has some cerakote erosion, as I call it, on the slide and other minor marks. See photos.
Trade for other firearms of interest- open (but no crossbows, hunting rifles, black powder anything, glocks and turkish shotguns)
Things that trip my trigger +/- cash, if needed:
DW Bruin 10mm
Nighthawk 1911
Wilson Combat 1911
Ed Brown 1911
Colt M45A1
Colt WW II 1911
Smith 657 or 57 pre
Smith 610 pre
Smith 310 Night guard
Smith 5906 Performance Center
Marlin JM .357 or .44
AK47 Maadi
Don't know too much about the below, so will be very picky...
M1A Garand- above rack quality
HK91
PTR-91
Galil
UZI
***Need to note, unfortunately, as it happened to me...once, and will only happen once. If I sell/trade a gun with you, and you take apart beyond the normal factory recommended procedures to clean/lube and it breaks...it is your problem. I don't know your gunsmith credentials, if any. I had to eat a gun I sold and this happened. I fully refunded without knowing the full extent of the damage. A couple of gunsmiths later, I was told, when in doubt on removing something involving threads, keep applying oil to loosen it up on a gun- DON'T manhandle it. Lesson learned for me, and now I am putting this disclaimer in.
***Guys, if you have to get permission from your husband to buy/trade with me, please block me.
Comes with 1 factory blued 10mm Colt magazine. Has some cerakote erosion, as I call it, on the slide and other minor marks. See photos.
Trade for other firearms of interest- open (but no crossbows, hunting rifles, black powder anything, glocks and turkish shotguns)
Things that trip my trigger +/- cash, if needed:
DW Bruin 10mm
Nighthawk 1911
Wilson Combat 1911
Ed Brown 1911
Colt M45A1
Colt WW II 1911
Smith 657 or 57 pre
Smith 610 pre
Smith 310 Night guard
Smith 5906 Performance Center
Marlin JM .357 or .44
AK47 Maadi
Don't know too much about the below, so will be very picky...
M1A Garand- above rack quality
HK91
PTR-91
Galil
UZI
***Need to note, unfortunately, as it happened to me...once, and will only happen once. If I sell/trade a gun with you, and you take apart beyond the normal factory recommended procedures to clean/lube and it breaks...it is your problem. I don't know your gunsmith credentials, if any. I had to eat a gun I sold and this happened. I fully refunded without knowing the full extent of the damage. A couple of gunsmiths later, I was told, when in doubt on removing something involving threads, keep applying oil to loosen it up on a gun- DON'T manhandle it. Lesson learned for me, and now I am putting this disclaimer in.
***Guys, if you have to get permission from your husband to buy/trade with me, please block me.
