taurus pt111 g2 sight issues

[Flashover16]

typically an improper sight picture and less than desirable trigger control.
additionally the weapon should be set up to run 124 grain ammo, so this might make a slight difference in POI, but not that much usually at closer ranges.

 

[10thmountain]

Sell it for $400

 

[Flashover16]

See if this helps any!!!

 

[tlw1179]

And the g2 is an easy gun to jerk since the trigger needs to go all the way to the grip. I had a low right issue. My neighbor is a lefty and im right handed and the gun shot in the exact same spot for both of us. I had enough to get the right out but not the left. 2 small slices of brass shim in a can under the rear sight solved the issue though. And there are aftermarket sights for the g2 but none are adjustable. Ive seen fiber optic and tritium sights (front only on the tritium) for them when i searched about 2 or 3 months ago

Got a link to fiber optic sites , other than modified shotgun sites? I've looked and see none for this model

 

[insulinboy]

I don't remember what site I found them on but I will look around and see if I can find them again

 

[insulinboy]

I run 115 remington HP with 5.0 grains of Ramshot Silhouette powder. I sight my pistols for dot on impact rather than pumpkin or half pumpkin

When I'm running 124gn factory or my loads (124gn bulletworks.com plated projectiles, 5gn of CFE pistol powder) the impacts end up in the same spot FWIW. Shooting from 27 yards. I measured my range to be 25 but by the time I was done building I ended up 27 from table to targets

typically an improper sight picture and less than desirable trigger control.
additionally the weapon should be set up to run 124 grain ammo, so this might make a slight difference in POI, but not that much usually at closer ranges.

 

[chewok23]

yeah i thought about filing the front sight, but i am going to wait to see what taurus has to say.....