Zenith MP5 or HK MP5

[USMC033run]

Not really. I had to use a dremel just a bit and fits fine now.

I know that HK and Zenith run push pin lowers. I'm assuming that you had to clip and pin that 4 position housing in order for it to fit? Are you running the stock PTR trigger pack internals or the internal trigger pack off the 4 position housing. Thanks for sharing the wonderful photo of your MP5! Very nice!

 

[Tactical Beaver]

I know that HK and Zenith run push pin lowers. I'm assuming that you had to clip and pin that 4 position housing in order for it to fit? Are you running the stock PTR trigger pack internals or the internal trigger pack off the 4 position housing. Thanks for sharing the wonderful photo of your MP5! Very nice!

Thank you! I did very little modification to make it work. Literally dremeled a tiny bit and it fit great. HK sent me one that was not clipped or pinned so I could use my existing push pins. Here’s a link to the specific one I bought. It was a very easy install/upgrade and has worked flawlessly. I hope this helps.

https://www.hkparts.net/shop/pc/Tri...Housing-0-1-Safe-Semi-Only-MP5-94-5p17236.htm

 

[Tactical Beaver]

You have to let them know though so they can send you one that’s not clipped or pinned so it’ll work. They have this special note when ordering specifically for the POF’s and Zenith ones.