Search results for query: *

  1. RMR Mill Out

    OK, what is a(n) RMR

  2. Winchester 1873

    Bill Schwartz in Blue Ridge can make you one from scratch

  3. Any leather workers? Need hepl

    I have a nice Holster that has a nice fit for the pistol it was made for. However to use it for other pistols that also fit more or less, I need to add a male snap so the restraining strap will secure the pistol better. I have the tools and the snap, but the stud that goes with it is too short...
  4.

    I am slap out of ideas?

    "you got to know when to hold-em, know when to fold-em, know when to walk away......."

  5. Gunsmiths

    Good work never was cheap

  6. AR-15 pivot pin stuck

    Thanks to all, Break free did the trick.

  7. AR-15 pivot pin stuck

    Thanks, I will try it

  8. AR-15 pivot pin stuck

    Stupid question.... The rear take down pin pops right out with thumb pressure. Would it be ok to try tapping the front pivot pin out with a wood dowel or delrin punch. It is the only rifle I have had with this problem. I would like to be able to separate the upper and lower for easier...
  9.

    Check the grain in this stock

    Here is an example of tiger maple (just for fun). I make these from scraps otherwise used for kindling.

  10. Southwest Ga barrel threading

    Try Nine Run Gun in Screven, GA. If you can separate the barrel from your receiver, the turnaround may be manageable. 912-207-0046
  11.

    Double barrel rescue from flood

    yes: It will never be safe to fire again without a lot of knowledgeable (aka "expensive") work.

  12. Reasonable & Competent Old School Gunsmith Needed

    Bear in mind that good work never was cheap. I am not sure where he is now but Bill Schwartz of of Big Buck Mountain road near Elijay is very capable.

  13. Checkering tools- want to borrow/buy

    https://www.dembartco.com/index.htm What you are looking for is a veiner. They come in either 60 or 90 degree angles, course and fine. I could send/loan you my 16lpi master set, but by the time you pay shipping both ways, you can buy one from Dembart and be done with it. Call them for a...

  14. Reducing the Colt sear block

    What does this "milling" accomplish/improve in the real world?

  15. What gunsmith do you use?

    I think you need an armorer rather than a gunsmith. There is (or was) a difference in skill sets.

  16. Nine Run Gun Rifle Builder?

    He is my neighbor and I have known him since he was knee high. He builds precision rifles mostly, occasional repairs-upgrades. He will not promise something he cannot deliver. He can consistently hit .0002" accuracy with his state of the art equipment. He will return all calls at the end of...
  17.

    Gunsmith in Ga. that can work on/rebuild a Citori

    unless you have a sentimental attachment to it, a Citori is not worth the cost of rebuilding. Most Citoris that have been "shot loose" have been ruined by their owners repeatedly slamming the action closed instead of merely closing it. Kept oiled and cleaned and using good ammo, it would take...

  18. small container of wood finish

    Hoage and Pachmeyer make excellent grips for the S&W line.
  19.

    Laser Engraving Services - I'm New Here

    American engraving???

  20. Old school Colt 1911 slide tightening?

    There is nothing money cannot fix.
Back
Top Bottom