300 blackout bolt gun

[CTS Tactical]

It is super light and joy to carry in the thick woods.
I'm debating on hinged floor plate. Not sure I'd want my rifle giving birth to live ammo. 🤔
But also don't care for mags that are not flush fit with stock...

That was my reasoning. Not at all fond of the Howa plastic bottom or the Magazine. Mine is .223 and I think it still left room for 4 rounds in the blind box mag.

 

[BigMike]

You can correct some of it by loosening the action screws and holding the barrel in the middle and torqing the screws back down to spec. 65-85 inlb per ruger

Hmm.. I need to snug mine then. I went to 30 in/lb when I reassembled mine after the trigger work.

 

[alexs2006]

You ended up with a good shooting gun that wasn't expensive. Which is a good thing in itself, right?

_

Oh yes! I am very happy for the money! Would buy again!

 

[alexs2006]

Hmm.. I need to snug mine then. I went to 30 in/lb when I reassembled mine after the trigger work.

I have torqued mine to 60inlb.

 

[1clearshot]

That was my reasoning. Not at all fond of the Howa plastic bottom or the Magazine. Mine is .223 and I think it still left room for 4 rounds in the blind box mag.View attachment 7929595

I'll likely end up with Oregunsmithing or Jefferson after deer season.
Howa plastic mag is nothing like the one on my Sako A7...

 

[alexs2006]

Hmm.. I need to snug mine then. I went to 30 in/lb when I reassembled mine after the trigger work.

What did you do to your trigger?

I couldn't resist the urge and I just ordered the glades armory bolt handle/Knob upgrade for the gen II. I will polish the heck out of the bolt body to smooth things up some while I have it apart.

I have some more test loads to try out on Saturday morning after my rimfire match.

Also, I don't know if I mentioned it before, but all my rounds have been shot with an AAC Ti-Rant 45 suppressor and the 300blk adapter. It actually suppresses it really well for being a pistol can.

 

[BigMike]

What did you do to your trigger?

I couldn't resist the urge and I just ordered the glades armory bolt handle/Knob upgrade for the gen II. I will polish the heck out of the bolt body to smooth things up some while I have it apart.

I have some more test loads to try out on Saturday morning after my rimfire match.

Also, I don't know if I mentioned it before, but all my rounds have been shot with an AAC Ti-Rant 45 suppressor and the 300blk adapter. It actually suppresses it really well for being a pistol can.

Dropped the pull weight. It's got a hex screw in it.

 

[BigMike]

What did you do to your trigger?

I couldn't resist the urge and I just ordered the glades armory bolt handle/Knob upgrade for the gen II. I will polish the heck out of the bolt body to smooth things up some while I have it apart.

I have some more test loads to try out on Saturday morning after my rimfire match.

Also, I don't know if I mentioned it before, but all my rounds have been shot with an AAC Ti-Rant 45 suppressor and the 300blk adapter. It actually suppresses it really well for being a pistol can.

I ran mine through my rex mg7 and my nomad L titanium.

 

[alexs2006]

Very nice!

So far, I really like this little rifle. Way more than I thought origionally

 

[alexs2006]

Hmm.. I need to snug mine then. I went to 30 in/lb when I reassembled mine after the trigger work.

This may be why your sig ammo was wildly inconsistent for you?