Case Sorting

[rinfanti]

Any one have a machine and could help a brother ODTer out?

I have about 350Lbs of brass to sort for a friends estate. Hand gun to big bore rifle.

I will do all the work.

Thanks in advance,

Ralph
~~~~~~~~

 

[Nuke And Juke]

This is always the hard part

Sent from my LM-G850 using Tapatalk

 

[JeepAdventure247]

I'll help sort if I can keep some

 

[rinfanti]

Actually sold them all last night. Thanks for the offer though.

 

[Nuke And Juke]

It’s probably best to sell the whole lot than to sort it out and then sell them


Sent from my iPad using Tapatalk

 

[gyppo]

I use three sorting pans. It separates 45 or bigger, 9mm or bigger and smaller.
It is not perfect, I still need to separate 223 and 9mm by hand but it is still better than sorting all of it by hand.

 

[JeepAdventure247]

I use three sorting pans. It separates 45 or bigger, 9mm or bigger and smaller.
It is not perfect, I still need to separate 223 and 9mm by hand but it is still better than sorting all of it by hand.

I've seee these and I was curious about them. Seemed like a good way to at least get it divided into thirds

 

[gyppo]

It saves a lot of time. I sometimes get a 5 gallon bucket of brass a week if I shoot 4 matches. After sorting, I primarily end up with 9mm, 380, 223 and 5.45x39 in a bucket. 40, 38 special and 10mm in. A bucket and 45 cap, 44 mag and 308 in. A bucket. The most pain in the neck round is 380. it is difficult for me to recognize and separate from 9mm. I often bend a decapping pin because if falls over in my press and bends a decapping pin, after about 5 times the pin breaks.

 

[JeepAdventure247]

380 also messes me up.