Hope this is the right place to post this!
Just bought my first NV IR device to go with my PVS7s, a DBAL i2!
However, I'm a little confused at how to zero the IR (and visible) on this thing. I constantly see reports of the two theories of zeroing, parallel and converging zero. Parallel meaning that it's offset, but parallel to the bore, and converging where the laser is pointing to where the optic was zeroed. Is there a preferred method for all you Dbal / PEQ cats out there? I know my PVSs are really only clear as day for about 50-75m or so. So should I just do converging?
What do all of you guys do?
Thanks for the info!
Just bought my first NV IR device to go with my PVS7s, a DBAL i2!
However, I'm a little confused at how to zero the IR (and visible) on this thing. I constantly see reports of the two theories of zeroing, parallel and converging zero. Parallel meaning that it's offset, but parallel to the bore, and converging where the laser is pointing to where the optic was zeroed. Is there a preferred method for all you Dbal / PEQ cats out there? I know my PVSs are really only clear as day for about 50-75m or so. So should I just do converging?
What do all of you guys do?
Thanks for the info!