I have some spare stuff laying around, and decided I needed a honey badger.
Here's what I have:
Complete upper reciever
10.5" 300BLK barrel that I just sent to Dobbs to chop to 6.5". (this will only be run suppressed so undergassed = good)
Older billet Ft Daniel lower that I'm going to mill out to an M16.
Saker 762 or a Harvester to put on it. Harvester allows more rail options since its skinnier, is lighter, but is longer. I'm not really worried about heat because this will only be run with subs and little FA. Saker is shorter, but heavier and wider. Both can be sucked under the rail because they are one hand on and off.
I've got PDW collapsing honey badger style stock comng.
It's going to wear a T1 or a RMR on it.
What I need:
A rail. This will be based on the can I pick. I'm wanting the can to stick out about 1.5" past the rail. All i need is a top rail for a PEQ15 to fit on it...


Got any suggestions?
Here's what I have:
Complete upper reciever
10.5" 300BLK barrel that I just sent to Dobbs to chop to 6.5". (this will only be run suppressed so undergassed = good)
Older billet Ft Daniel lower that I'm going to mill out to an M16.
Saker 762 or a Harvester to put on it. Harvester allows more rail options since its skinnier, is lighter, but is longer. I'm not really worried about heat because this will only be run with subs and little FA. Saker is shorter, but heavier and wider. Both can be sucked under the rail because they are one hand on and off.
I've got PDW collapsing honey badger style stock comng.
It's going to wear a T1 or a RMR on it.
What I need:
A rail. This will be based on the can I pick. I'm wanting the can to stick out about 1.5" past the rail. All i need is a top rail for a PEQ15 to fit on it...



Got any suggestions?


