I'm all excited....

[bluesman2a]

Ordered:
2 S&W disconnects
2 W/C stainless plunger tubes
2 W/C factory plus sears
2 Sets of grip screw bushings
2 Stainless ejectors
2 Night Hawk match triggers
2 Titanium hammer struts
2 Stainless Colt mag releases
Did I miss anything?
Already have beavertails, MSH(complete), leaf springs, Pin sets, grip screws, grips, plunger tube staking tool, I think that covers it...If you see something I missed TELL me!

I only ask because I was bitten myself on a couple of these:
plunger spring (it's not included on any kits)
On your mag releases are you SURE it comes with the spring and release pin? (many of them don't).
Recoil spring?
Guide rod?
Reverse Plug?

 

[geezer]

Thanks Bluesman...good points there...I have plunger springs and pins already. If the mag releases come stripped, I have a few springs and pins, but Not sure If I have stainless pins. Have 3 complete uppers so all that part of it is good to go. Thanks for inspiring me to look a little deeper.I think I'm covered...

 

[bluesman2a]

If you don't mind my asking, where are you sourcing your parts from? I've been using a couple, but had never thought to look at CDNN, some good deals there. Any other places we should look?

 

[jglenn]

only issue with CDNN parts is that most all are MIM if that bothers you...

these days lot's of quality pistols have MIM parts.. hell COLT has nylon mainspring housings ???