-info found, thanks!-

[GoNoGo]

Thanks, found !!

 

[PopsBwell]

Bench grinder?....

 

[PopsBwell]

Sorry serious question.... REloaders out there,,,, anyone?

 

[Petro_58]

This is what I use and Have for years. Not sure about Pulling 50bmg though.

http://www.midwayusa.com/find?userSearchQuery=Bullet+Puller

 

[ATLEMT]

A gun will separate the bullet from the case nicely.

But in all seriousness I've only ever used pliers, a bench vice, and some elbow grease. But I've never tried to reload them after that.

 

[Ironhead]

hammered / loaded is pretty nice after a 12 pack... lol

really though, i've seen the bullet pullers that look like a hammer and thought... do you really want to beat on a bullet with one of those?

and i agree... mine separate nicely in the chamber

 

[Deleted member 20875]

http://www.midwayusa.com/product/215517/frankford-arsenal-impact-bullet-puller


This is the one I use and it holds up good

 

[Chuckdog]

I've been using the kinetic type for years. No problems at all. You're not pounding on the primers.

The .50 would present a size problem for any I've seen.

 

[Shovelhead]

Inertia hammer but for 50BMG real problems. As far as reloading components you're probably OK with bullet I.d. and weighing them but what about the powder. I certainly wouldn't take a chance in trying to I.d. Powder

 

[Springfield 1911]

http://www.midwayusa.com/product/215517/frankford-arsenal-impact-bullet-puller


This is the one I use and it holds up good

I've got this same one. I like it better than my collets because its faster. I just use a shellholder instead of the rubber band aluminum crap. Make sure if you use this one to tighten it up every other swing or so.