Installing sights on a m&p

[J hex]

I have a M&p and a set of new fiber optic sights. Can anyone install these for me of point me in the right direction on where to go. I have no problem paying I just don’t want to deal with shipping or weeks of turn around time. Thanks
Ted

 

[shootsacanon]

I bet cmshoot could do it for you at TruPrep while you wait.

I will say, I did a set on my Shield 1.0 with a $50 sight pusher from Amazon, but it was tough. S&W - at least on the Shields - really seemed to put the rear sight in tight. It's been a few years, so I don't recall exactly, but I had to do some combo of hot & cold (I recall putting the slide in the freezer) to get the rear sight to budge. The TFOs I installed went in easier than the stock sight came out.

 

[chopps]

Drift with brass punch

 

[cmshoot]

I can do it for you while you wait at TruPrep in Marietta. Usual fee is $20.

 

[J hex]

That sounds good I will bring it by there.

 

[David's Gun Room]

Yeah thats easy we can make it happen, not while ya wait though, good bit of smithing in rn.

 

[cskiles]

I can do it for you while you wait at TruPrep in Marietta. Usual fee is $20.

Once again, cmshoot offering terrible customer service and trying to screw someone! LOL

 

[Pond Scum]

Good videos on You tube for this.