Hi all,
I'm selling a nearly complete 727 clone. It has a 14.5" Colt M4 gov't profile barrel, dated 05/08 and C MP marked, which is in very good condition and came from a police rifle, so better condition than milsurp. The A2 birdcage is just hand spun on to protect the threads since I had planned to pin and weld a longer muzzle device. The upper receiver is an FK marked A2 upper. Handguards are not colt, but they do have a cage code stamped on them, and are skinny 6 hole. Comes with toolcraft nitride BCG and 7075 mil-spec charging handle.
Lower I built from a stripped lower from savage. It has very minimal markings and I used it because the color of the anodizing matches the upper pretty much perfectly. Used a SOLGW blaster starter kit for LPK, and added a mil spec trigger and A2 grip I had sitting around. Buffer tube is from BCM, and buffer is an H2 from KAK.
I'm selling this as a pistol, as I said I had planned to pin and weld to 16" with longer flash hider, but if someone purchases it you can chose to either go the pin and weld route or possibly a pistol brace if they are not banned. Leaving it as a pistol leaves it up to the purchaser. I used quality parts since I had planned to keep this build, but I've kind of lost interest. I used aeroshell grease on the barrel extension and barrel nut threads when installing the barrel.
The price for the build as is is $1150.
Thanks for looking.
I'm selling a nearly complete 727 clone. It has a 14.5" Colt M4 gov't profile barrel, dated 05/08 and C MP marked, which is in very good condition and came from a police rifle, so better condition than milsurp. The A2 birdcage is just hand spun on to protect the threads since I had planned to pin and weld a longer muzzle device. The upper receiver is an FK marked A2 upper. Handguards are not colt, but they do have a cage code stamped on them, and are skinny 6 hole. Comes with toolcraft nitride BCG and 7075 mil-spec charging handle.
Lower I built from a stripped lower from savage. It has very minimal markings and I used it because the color of the anodizing matches the upper pretty much perfectly. Used a SOLGW blaster starter kit for LPK, and added a mil spec trigger and A2 grip I had sitting around. Buffer tube is from BCM, and buffer is an H2 from KAK.
I'm selling this as a pistol, as I said I had planned to pin and weld to 16" with longer flash hider, but if someone purchases it you can chose to either go the pin and weld route or possibly a pistol brace if they are not banned. Leaving it as a pistol leaves it up to the purchaser. I used quality parts since I had planned to keep this build, but I've kind of lost interest. I used aeroshell grease on the barrel extension and barrel nut threads when installing the barrel.
The price for the build as is is $1150.
Thanks for looking.