Suppressor alignment after gunsmith installation

[BigMike]

I hate to mention this, but check to be sure the crush washer was not used when they installed the muzzle device.

I'll add, you don't have to rocksett suppressor devices to keep them from coming loose.

 

[K79540]

Shoot it

 

[Dirty J]

I hate to mention this, but check to be sure the crush washer was not used when they installed the muzzle device.

I'll add, you don't have to rocksett suppressor devices to keep them from coming loose.

If anyones using a crush washer on a QD suppressor muzzle device… they don’t belong anywhere near a gun!

 

[JDUB]

Step bit…drill it…comon!!!

 

[BigMike]

If anyones using a crush washer on a QD suppressor muzzle device… they don’t belong anywhere near a gun!

Not everyone knows that and "gunsmith" is a loose term around here.

 

[marksman17]

I hate to mention this, but check to be sure the crush washer was not used when they installed the muzzle device.

I'll add, you don't have to rocksett suppressor devices to keep them from coming loose.

Dead air shims used and rocksett on all my mounts

 

[marksman17]

It’s not their job to re-machine out of spec parts.

Install and alignment check doesn’t mean they fix a potential manufacturing defect for a marginal (I’m sure less than $100) fee.

No but letting you know they’re out of spec is their job

 

[Tiamat]

Threading a barrel for a suppressor is much different than threading for flash or comp.

 

[Construct More Pylons]

Send it! It sounds like tolerance stacking might be the issue.