Well I finally got around to it I finally filled out and submitted my ATF Form 1 so that I may finally get to own a SBR. I have to say I'm pretty excited and I hope the next few months go by quick.
It will be a Frankenstein SBR cause I just couldn't bring myself to spend over 800 dollars on a SBR
-Upper receiver will be Range Tool Blemished Upper
-Red X Surplus 300 Blackout 7.5 inch chrome stainless barrel
-AT3 Tactical 7 inch free floating quad rial
-Ares Armory Bolt carrier
-BCM extended charging handle
-Modle 10 Muzzle break
-Lower is AR Fifteen lower
-PSA Lower parts kit
-Magpul FDE Furniture
But once my approval comes in I will need somebody who can do some engraving for me? Any recommendations?
It will be a Frankenstein SBR cause I just couldn't bring myself to spend over 800 dollars on a SBR
-Upper receiver will be Range Tool Blemished Upper
-Red X Surplus 300 Blackout 7.5 inch chrome stainless barrel
-AT3 Tactical 7 inch free floating quad rial
-Ares Armory Bolt carrier
-BCM extended charging handle
-Modle 10 Muzzle break
-Lower is AR Fifteen lower
-PSA Lower parts kit
-Magpul FDE Furniture
But once my approval comes in I will need somebody who can do some engraving for me? Any recommendations?
Last edited: