Here is a coil that will blow your lid off. 0.2 ohms. It's pushing 68.45 watts. It takes a few seconds to warm up but when it does good lord
It's two pieces of 28 gauge kanthal twisted as tight as I could get it. Damn things are almost touching the top cap walls lol
congratulations on your big 1st step. imo, (and if I may) you should enjoy the vaping experience and avoid consuming yourself w/ cutting down your nicotine level just yet -- you've been hooked on [*gasp*] carbon monoxide, copper, tar, acetone, ammonia, arsenic, benzene, butane, formaldehyde, hydrogen cyanide, methanol, methane, toluene, ddt, radon, polonum, nicotine and some other mind altering drugs for 24 long years
. nic dependency is no different than caffeine dependency, hence why it's deemed a much safer alternative; especially in contrast to what you're up against. (more info)
you think??
I can't stress the importance of keeping tabs on your coil's resistance enough (especially on sub-ohm builds) and of course staying within the battery specs. there's a very small room for error before it leaves a bad taste in your mouth ... just sayin', bro 
. oh, and i've managed to blow some serious clouds with a .7/.8 dual coil builds on the same exact setup that you have; you don't really need to go that low -- that's totally up to ya though.you're not gonna see much vapor production on a 50/50 blend. If you're plan is strictly cloud-chasing, go with a heavier/all vg and widen the air holes (if you/heisenberg haven't done so already). also keep in mind that by going all vg, you will be sacrificing the flavors by moderately muting it.
I've been going through the cinnabon since I left v8p. think i'm gonna change my cotton in the morning and test-drive it all day.
I think once this one breaks I'm gonna stick with mech mods.
