I would be very appreciative if somebody with a Gen4 Glock 17 or 34 could take two measurements for me. I zeroed my calipers and made sure to get it tight and square against measuring surfaces. First measurement is locking lug:
Next measurement is a little more difficult. I made calipers sit square and flush with the shroud, as deep as they will go. Then I made sure that the other jaw of caliper is sticking up the exact same amount over top of the barrel.
For anybody interested, measurement 1 on my '09 G17 Gill was .810" and on my KKM barrel was .817". Measurement 2 on my Gill OEM barrel was 1.218" and on my KKM 1.220".
Would be awesome to get measurements from any other gens and barrel makers too!
Next measurement is a little more difficult. I made calipers sit square and flush with the shroud, as deep as they will go. Then I made sure that the other jaw of caliper is sticking up the exact same amount over top of the barrel.
For anybody interested, measurement 1 on my '09 G17 Gill was .810" and on my KKM barrel was .817". Measurement 2 on my Gill OEM barrel was 1.218" and on my KKM 1.220".
Would be awesome to get measurements from any other gens and barrel makers too!
