Rear Flip Kit for '07 Tundra ??

[H2O MAN]

The SOS kit I will be installing when the new leaf springs arrive.

 

[atljetmech]

Interesting twist.
I've always lifted the front of trucks to level them out.
In for final pics of your project.

 

[bass222000]

I installed the TRD Rear swaybar on my '10 Tundra Crewmax 4x4. Made a big difference, I love it.

 

[H2O MAN]

http://www.fourwheeler.com/how-to/suspension-brakes/131-1305-the-wonder-of-spring-under-suspension/

 

[furious]

Does the '07 Tundra have a rear brake proportioning valve? Proportioning valves change brake pressure with axle height. High pressure without a load will lock your rear brakes with minimum pedal movement. At speed, this is very dangerous. The axle side of the valve switch arm needs to be relocated to the proper angle.

 

[H2O MAN]

I have not seen anything to indicate the BPV is an issue from '07 forward, but I seem to recall this issue when I lifted my T100 a little bit, an extension was used to keep the BPV in the same position it was pre-lift.

 

[furious]

I have not seen anything to indicate the BPV is an issue from '07 forward, but I seem to recall this issue when I lifted my T100 a little bit, an extension was used to keep the BPV in the same position it was pre-lift.

I wonder what Toyota did in '07 to replace the mechanical valves?

 

[H2O MAN]

There is a fix if I was lifting the truck, but it's not needed with this drop to the rear.

I don't think anything has changed with Toyota's mechanical valves.

 

[H2O MAN]

These are the current measurements, rear & front.
If everything goes as planed, the rear will drop & match the current (unaltered) front.

 

[H2O MAN]

Installation happens tomorrow!