Reload 9mm Could use some advice

[Clarke123]

Tightgroup is excellent in 9 mm, but watch out for overloads as the loads have a very narrow range.
an extra half-grain can cross you over into "the danger zone"
I use Universal (NOT Clays) for most of my target loads as it has a larger range of loadings (therefore less
likely to overcharge by accident)

Insomuch that a lot of the 9 mm brass you may pick up will have "the Glock bulge" ... Having a case gauge is recommended

 

[inkdaddy]

www.handloads.com

 

[Early9973]

Thanks

 

[watchingtrace]

titegroup , but its like trying to capture unicorn tears. anything 124gr or above on bullet

 

[Early9973]

Has anyone used Nitro 100 NF powder before and has anyone ever tried reloading ZQI brass when i tried to crimp it it mashed down and buldged

 

[RamRoddoc]

Has anyone used Nitro 100 NF powder before and has anyone ever tried reloading ZQI brass when i tried to crimp it it mashed down and buldged

Back your "taper" crimping die out 1/8 turn until the bulging stops, then just a bit more.

 

[Early9973]

IT only did it on 4 pieces