Tips on removing AFG?

[Cadcom]

I am trying to remove the Magpul AFG from an AR I recently traded into. I have removed the screw but this thing will not budge! Any tips on how this thing comes off?

 

[dakota port]

hopefully they did not force it in place with a hammer, some rials don't fit certain magpul accessories without persuasion

 

[DMGun]

You AFG needs a BFH.

 

[Cadcom]

Just got pissed and whacked it.

Issue resolved!!

 

[dakota port]

Just got pissed and whacked it.

Issue resolved!!

sounds like the rail didn't want ot take the afg so the previous owner forced it on and you forced it off

 

[BangBang]

Just got pissed and whacked it.

Yeah, but what about the AFG?

 

[Cadcom]

I think it is just a tight fit. Rail and AFG are both unscarred and look like new.

Now does anyone want to buy this rail section and AFG?

 

[Wallace's]

I think it is just a tight fit. Rail and AFG are both unscarred and look like new.

Now does anyone want to buy this rail section and AFG?

Mine slips on off my KAC RAS without too much effort. As noted above, some rails can be a pain to get them on and off of, especially if its a polymer rail section.

And for the parts, I give about tree fiddy.

 

[Cadcom]

I'll take the tree fiddy and can finance the balance, but you dont want to know the interest rate!

Here is my junk: http://www.theoutdoorstrader.com/threads/fs-ft-ar-trinkets-afg-vert-grip-furniture-etc.934842/

 

[3clicks_Off]

Put it in the freezer for an hour or so and when you get it good and cold, use a heat gun on low or a hair dryer to heat only the AFG on the sides, then try to bump off with a rubber mallet. Good luck