Spent the last few Saturdays installing an Atlas 2 post lift in my new shop. Since this is in Alabama I really don't have any help. I thought and thought about how to raise this heavy SOB with what I have and finally came up with a plan. I assembled the lift with it sitting on four furniture dollies. I then positioned it where I thought it would end up in my layout lines. I used some dense thin foam to prevent gouging the concrete. I knew the boom pole on my tractor would have limited travel so I first lifted it as high as possible with my engine hoist. Adjusted the boom pole and started the lift at that point. It was quite a puckering experience when it finally tipped into place but it ended up within 1/2 inch of where it should have.