I am having problems with my XL650 depriming 9mm brass. It is not pushing the primer out in about 1 in 10 cases. It is a Dillion die with about 7-8k loads through it. Mixed head stamps. It just started all of a sudden. Here is what I have checked:
Die is as far down on shell plate as possible.
Installed new pin in die.
Inside of die is clean.
Checked case length on brass that failed to deprime. None exceed max case length in my reloading manuals.
I have no idea what to do other than purchase a new die and try that.
Any ideas?
Die is as far down on shell plate as possible.
Installed new pin in die.
Inside of die is clean.
Checked case length on brass that failed to deprime. None exceed max case length in my reloading manuals.
I have no idea what to do other than purchase a new die and try that.
Any ideas?