How many ghosts were you wanting?
-
ODT Gun Show & Swap Meet - May 4, 2024! - Click here for info
Show your 3D prints
- Thread starter Ravic
- Start date
2-3-4 whatever is not inconvenient.
Looks like I can do 2-3 ghosts per spool. They use more than I thought because of all the support layers on the inside of them
My buddy made me a bottle opener in the shape of my car. I explained that my car was in fact NOT a Mustang, but rather a GTO, and he replied, keep it anyway. I did…
Pm coming
For anyone who has a Traxxas XMAXX. I can make you hood skid plates. Not my design so I will not profit off it
Hoffman tactical 3d printed lower. Psa upper
Curious, I printed a couple G19 test frames upside down like that and found it a real pain in the backside to attempt to clean up the supports out of all the areas with important tolerances. I switched to printing upright so that most of the supports were outside of the frame (On the bottom specifically) and found it MUCH easier to clean up the supports.
I also didn't care much for the smooth grips on the particular STL that I grabbed. At some point I'm going to get motivated enough to add some texturing to the grip area and reprint as a test. It was just a science experiment for me but turned out to work surprisingly well.
Similar threads
