it's a 4cycle engine!
Small Engine Mechanic ??? (UPDATED, got'r fixed)
- Thread starter SouthernSlammed
- Start date
it's a 4cycle engine!
It's a briggs&stratton 04500... at least that is the number on it.
this site is the only one I can find any parts for it, and they list it as AA0101-0001
Briggs and Stratton AA0101-0001 Parts List and Diagram : eReplacementParts.com
Does it have the rev limiter?
Did you get this new or used?
Did you get this new or used?
I would open the exhaust valve to .007 or .008
Not one that adjusts. Throttle bracket has a tab, and there is a casting stop on the carb.
Used, but I have been through it to get it to start. OP has everything I have done to it, - valve adjustment.
Briggs and Stratton Valve Clearances
Honda Small Engine Intake and Exhaust Valve Clearances
Scroll down the link and this addional clearance for the exhaust valve is what I found.
I'm working on a Honda GX390
Honda Small Engine Intake and Exhaust Valve Clearances
Scroll down the link and this addional clearance for the exhaust valve is what I found.
I'm working on a Honda GX390
Well it is a cheap adjustment and you can double check the clearance.
I didn't have the spec earlier, the gx overhead valves are all 5-7 intake 7-9 exhaust.
It sounded like it was loping. I'm still working on mine so it intresting.
Briggs and Stratton AA0101-0001 Parts List and Diagram : eReplacementParts.com
This seems like a better link.
And this has audio:
Engines RPM seems to fluctuate-runs rough
Perhaps the magneto needs cleaning or adjustment. (Armature air gap)
I didn't have the spec earlier, the gx overhead valves are all 5-7 intake 7-9 exhaust.
It sounded like it was loping. I'm still working on mine so it intresting.
Briggs and Stratton AA0101-0001 Parts List and Diagram : eReplacementParts.com
This seems like a better link.
And this has audio:
Engines RPM seems to fluctuate-runs rough
Perhaps the magneto needs cleaning or adjustment. (Armature air gap)
