I'm rusty working on cars. My latest venture went south when I applied too much force to a caliper bracket bolt.
I have a good sized hole drilled through the bolt piece remaining inside the hub assembly.
There is not enough proud to get enough grip with the channel locks.
I'm thinking of epoxying a through bolt and putting a double nut on it so I can put a wrench on both sides.
I would probably just replace the hub assembly before I would buy a welder.
I might be able to increase the hole and collapse the piece in place.
Ideas?
I have a good sized hole drilled through the bolt piece remaining inside the hub assembly.
There is not enough proud to get enough grip with the channel locks.
I'm thinking of epoxying a through bolt and putting a double nut on it so I can put a wrench on both sides.
I would probably just replace the hub assembly before I would buy a welder.
I might be able to increase the hole and collapse the piece in place.
Ideas?