help me with glock slide release

[sheep dog]

I am out now but will try some of yalls ideas when i get back. Thanks and keep it coming

 

[Gimli2]

He took a good picture it appears to be correctly installed, so that's not it.
What else ya got?

Fat lot of nothing, so far. Wish I could get my hands on it!

 

[Patronus]

Correct slide stop seat into mag follower.

 

[Patronus]

Yeah, I know it needs cleaning.

 

[Rolling_trip]

I am referring to the slide lock release that catches the front left lip of the mag when inserted

That's what I was trying to show. The lever covers the 9 on my slide release. Is your mag deformed?

 

[Patronus]

I'm having a hard time with that first picture, but it looks bent right?
As I said I can't see it very well, but I'm agreeing that what I do think I see, doesn't look right.....

Yes. It looks like it's bent up and away from the follower. A simple tweak down should fix it. But if he's tried two different stops and BOTH of them are bent...?

 

[Patronus]

So my g19 will NOT slide lock back after last round and that causes mag release button to not work either. Reason is the slide lock is not catching the lip of the mag but on the side of the lip as in pic below. Swapped out for another slide release and still doing it. Any ideas?

DEFINITELY bent away from the follower.

 

[biker_bill]

Ok Sheepdog I took a couple pictures for you. Which I found difficult to do even with proper lighting.
The tab on the slide lock DEFINITELY contacts the magazine and enough to push the slide lock up a bit when the magazine is inserted and the tab is in the magazine notch.

A picture of the tab in the magazine notch and one showing the position of the slide lock release when it's in.

 

[biker_bill]

So if yours doesn't look like the ones in my picture bend the tab down and try it again.
Should be nothing to bending it up or down a little....

 

[biker_bill]

Yeah, I know it needs cleaning.

No kidding bud, no kidding!