Thick weird 9mm brass
- Thread starter bulletpaluza
- Start date
I have reloaded similar and had no problem problems, but I only use 3.8 tite group on a 124 plated ball
Sent from my iPhone using Tapatalk
It wouldn't go through my decapping/sizing die stopped the press in its tracks.
I will see if I can find the ones I have and a case stamp. I use a Dillon 550 and Lee dies.
Sent from my iPhone using Tapatalk
I was on my 550 but with dillon dies.
http://forums.brianenos.com/topic/249758-stepped-brass/
There is a good thread on the topic. I've culled out Maxxtech, FM, and I think one other type of stepped brass. Since I run a max load of N320, I could see if getting real spikey in pressure if one slipped by.
There is a good thread on the topic. I've culled out Maxxtech, FM, and I think one other type of stepped brass. Since I run a max load of N320, I could see if getting real spikey in pressure if one slipped by.
Just looked, Ammoland is the third stepped headstamp type I've found.
Ammoload, FM and IMT all have the stepped shoulder inside the brass. I reload those with no problem. However, I usually separate them so all the brass I load have the same load and stepped brass. I use 4.1 grains of titegroup on the 115 grain bullets and 3.1 on mu 145 grain bullets.
