So what's stoppin' ya?
well, so far i haven't got a answer on what to clean gun with. just wiping down won't get all oil. hope that answers your question.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
So what's stoppin' ya?
well, so far i haven't got a answer on what to clean gun with. just wiping down won't get all oil. hope that answers your question.
I just use CLP. Barrel is like any other, bronze bore brush inside until it's clean. Patch it and wipe off all excess carbon from feed ramp and barrel breech end. Clean slide like you would any other. Frame and plastic just wipe down with cloth, use small amount clp on cloth to remove any caked on carbon. Only oil on the glock should be on the four steel tabs that the slide rides on and the connector. You can add a drop of oil on top of the barrel just in front of the chamber if you like on the camming surface. Other than that, that is all that is needed. DO NOT OIL THE STRIKER SLEEVE AREA. It is self lubricating and does not need any oil. It just gunks it up.
Too much oil? Pffft, I just Locked the slide back and sprayed clp down in everything, then shook it ou.
just take it apart and wipe the excess oil off. I doubt you have to go through a full cleaning.