Show Your Reloading Bench

[spar1790]

Thanks. The table top is two sheets of 1/2'' bolted together, I hope its not to thin. Bolting it to the wall and floor sounds good to me. Thanks for the suggestion.

 

[wynnjammer]

looks good like ammo locker

 

[spar1790]

thanks wynnjammer..

 

[wynnjammer]

http://tinypic.com/view.php?pic=2vvwfad&s=7

 

[WakeSS]

I just started reloading last week but here's my setup so far.

I love the Dillon SDB so far but, I want to load rifle calibers as well. I'm trying to decide if I should sell this. Get a 550/650 to do everything on or, keep it just for 9 and 45. I see most of you have multiple presses. Any advice either way?

 

[ngcsugrad09]

I just started reloading last week but here's my setup so far.

I love the Dillon SDB so far but, I want to load rifle calibers as well. I'm trying to decide if I should sell this. Get a 550/650 to do everything on or, keep it just for 9 and 45. I see most of you have multiple presses. Any advice either way?

Keep it for and add another. If you find you don't use it after you get the bigger press, then sell it.

 

[wynnjammer]

looking good for a start up. I love my Dillon's 650 & 550!!!!!!!!!! Keep It . Add one

 

[joestef214]

Here is mine in middle of an upgrade

slow start so far but gradually building to respectability

 

[Grub Master]

I just finished this room a couple of months ago and started reloading 6 week ago. Here is the bench for my Dillon and brass storage. I have another smaller bench for a single stage set up. I clamp the Dillon to the bench because I haven't decided where to put it yet. The picture was taken 3 weeks ago and is now covered up with bullets so I need to build some shelves plus get the scales at eye level..

 

[rbstern]

Grub, I think you might need some more lighting.