scorpion evo 3 stock, where to buy?

[albatros43]

Gotta have all that fancy paperwork to get a stock?

Yep

 

[RiverBend]

country folks superstore in Cumming has one on the wall

 

[wgatactical]

I like the look of the Troy micros, I'm planning on getting another set and adding a Blitzkreig components chevron front sight post.

 

[Dirty J]

cr107 how do those sights compare to AR height? Same? Lower?

I'm trying to find something in between the CZ sights and AR height.

 

[cr107]

cr107 how do those sights compare to AR height? Same? Lower?

I'm trying to find something in between the CZ sights and AR height.

They are smaller than the AR sights. I wish I had a set to compare them to. They are made for the HK416 and rifles with higher rail systems due to pistons.

Ill get another picture with the sights off of the scorpion to give you a better idea.

 

[Dirty J]

They are smaller than the AR sights. I wish I had a set to compare them to. They are made for the HK416 and rifles with higher rail systems due to pistons.

Ill get another picture with the sights off of the scorpion to give you a better idea.

Picture would be nice. Measurement even better.

Height from top of Pic rail to top of front post would be most helpful.

 

[cr107]

Ive decided I don't like them. Using a friends SBR'd scorpion I put the micros on it. They sit way too high with the factory stock to be usable/practical.

Hope this helps.

 

[cr107]

Top measurement is rail to tip of front sight post

Bottom is rail to top of rear sight aperture.

 

[Dirty J]

Thanks for the numbers.

I measure about 0.55" on the stock CZ sights.

1.4" on Magpul AR sights.


I tried an AR cowitness riser on my red dot and found it just a bit too high. The low mount is just a smidge too low for my liking.

I think those HK sights are a decent height... though I'd rather see them right around 1.0"

The trouble then would be how to get a cowitness on my red dot with the HK sights. Hmm

 

[cr107]

That's what I'm trying to do. Wish my Sparc would show up.