He does 3d printing, and has made me a few display stands….I challenged him to come up with a mag “filler” to allow the use of CZ P09 mags in the P07, and prevent over insertion(its real)…. Here are a few of his first attempts…
P09 mag in a P07….needed to fill that gap, and stop the mag at the right insertion depth…
Bowfishermans spacer…I like the finger notches that allow positive purchase on the mag base upon removal…
As a side note, these guys also fill the gap when using a P10c mag in a P10s.
again, this is the first attempt, and they work well…. Things will only get better from here…
P09 mag in a P07….needed to fill that gap, and stop the mag at the right insertion depth…
Bowfishermans spacer…I like the finger notches that allow positive purchase on the mag base upon removal…
As a side note, these guys also fill the gap when using a P10c mag in a P10s.
again, this is the first attempt, and they work well…. Things will only get better from here…